Design And Construction Of Microcontroller Based Domestic Remote Control System

Design And Construction Of Microcontroller Based Domestic Remote Control System

Chapter One

Preface

Ideal Of Design

The need for a remote control alert system that can control domestic appliances and colorful lighting points and sockets has frequently been a concern for druggies. At times druggies find it inconvenient and time consuming to go around turning their appliances on or off each time there’s power outage or each time they’re leaving the house for work. It has also frequently led to damage of appliances due to the fact that an appliance wasn’t turned off before leaving the house.

The ideal of putting up this design, thus, is to design an outfit that can grease a accessible and easy way of controlling our domestic appliances, lighting points and sockets especially in powering them, without always going to appliances physically by ourselves.

This ideal will be fulfilled using colorful factors which include a Microcontroller( AT89C51) which acts as the backbone of the design together with other factors.

Defense Of Design

The ease of putting our appliances, lighting points and sockets on or off has made it necessary to develop this system in order to control our appliances, lighting points and sockets from a central point using a remote control. The issues of always forgetting our appliances ON when leaving the house has frequently caused fire outbreak and explosion in homes and this is another reason that led to designing and construction of this design.

Compass Of Diagrams In Project

In this design report, the plates will range from simple block plates to complex circuit plates which will comprise substantially of common electrical and electronics symbols. Some of the plates that will feature in this report will be used as the main block on which certain parameters will be explained upon. Applicable electronic factors will also be shown and described.

This design report will also contain an figure of the circuit illustration as it’s seen physically. The package design illustration will be included showing the range, height in millimeter( mm).

BLOCK DIAGRAM OF PROJECT

Fig1.0 Block illustration

Design Report Association

Chapter 1 serves as the introductory chapter where I try to bear the conception and respectable reasons why the design should be enforced for the intending stoner of the work. therefore, showing the block illustration of the design and a compass of illustration for the entire design design.

Chapter 2 deals with the literature review where it’ll be agitating the origin of this design design. In the origin of the design, we will be looking at what brings about the three phase chooser in our day to day exertion and how the idea of designing this design comes about.

A description of the Project is also given where the 2 sections of the design are bandied and the colorful factors contained in the sections also mentioned.

The use and significance of this design design will also be mentioned then. It’ll be looking at the stylish place where this design design can be use and where it can not. This chapter will also make room for adding fresh information that will help in the fruition of this design design.

Chapter 3 treats the methodology of this design design. It comprises of the information gathering; the source of the accoutrements used in designing and writing the design report, data analysis; the factors and bias used in the course of designing this design will be analysis to know their introductory means of operation and how they will help in putting up this design, system design approach; the possible way to dived the design design from scrape, bottom- up; it’ll treat how the practical detail was gotten before considering about the general principle of the system design, choice of design system; it focuses on why the design design was done using a microcontroller rather than using only digital sense, and also the data inflow arrangement and system inflow map.

In chapter 4, the detail design work will be presented. It’ll include the schematic of the design of the colorful sections of the design and the source law( in C language) used in programming the microcontroller.

Chapter 5 will be agitating the system testing, Anticipated results, and Performance evaluation.

Summary and conclusion of the design will be presented in Chapter 6. It’ll be looking at the problems encountered in designing the design and possible results to them. From the problems and results of this work, the suggestion for farther enhancement will be stated.